Results

Deterministic Simulation:

the results of the deterministic simulation are shown here.

Critical Events:

the tab with the critical events is displayed here (a partial result of the stochastic simulation)

TSS Loads:

the tab with the TSS loads is displayed here (a partial result of the stochastic simulation)

TSS Immissions:

the tab with the TSS immissions is displayed here (a partial result of the stochastic simulation)

Individual Runs:

Parameter values and results for each simulation run are listed in a table. Each column contains a parameter or result. Each row contains one run. The first row (index 0) contains the values of the deterministic simulation (average values). If you move with the cursor over the column labels then the full description of the parameter is displayed in the hint.

Parameter Distribution:

This option shows a chart for each combination of varied parameters and results. The varied parameter (e.g. contributing area) is displayed on the x-axis and the result (e.g. number of bedload events) is shown on the y-axis. Each point in the chart is one simulation run. All charts for the same parameter and all results are listed horizontally in a row, whereas all charts for the same result and all parameters can be found vertically in a column. The last row shows the parameter distributions. The "grid" of all these charts is displayed in a reduced form in the navigation window (mode of the sensitivity analysis).